TufSkinz Peel & Stick Wheel Spoke Accent Kit for the Polaris Slingshot SLR (2017-18), SLR (2022-2025) & R (2020-2024)

Polaris Slingshot SLR & R Series Peel & Stick Wheel Spoke Decal Kit by Tufskinz (15 Piece Kit) NOT RECOMMENDED FOR MACHINED FACED (Black w/ Silver) WHEELS
We launched a colored wheel trim kit back in early 2019 that was specifically designed for the Polaris Slingshot to add a sporty pop of color to the trim of your stock wheels.  Due to the success of these trim kits and multiple requests by you guys, we went back to the drawing board with our friends over at Tufskinz to bring you guys a wheel spoke kit that accents each individual wheel spoke for a truly unique and custom look.  Not only do they look stunning as a stand-alone kit, but they're also compatible with our previous wheel trim kits, furthering your slingshot's custom wheel look.

Now, if you're unfamiliar with our Tufskinz product, the Tufskinz product begins with high-quality substrates, they're then coated with a UV-resistant top coat that protects the kits from Mother Nature, and then they are backed with 3M VHB backing tape for maximum adhesion. These kits are available in most OE paint colors so that once installed, your factory wheels will look as though they've been custom painted to match your slingshot's paint color.  

Before installing, keep in mind that the front two wheels have a smaller diameter than the rear wheel, so be sure you're installing the correct kit on the correct wheel. Also, make sure your wheels are super clean and free of dirt, grease, and other debris. This will ensure maximum adhesion to the wheel's surface. We'd recommend washing the surface of the wheel until it's squeaky clean, then hitting the adhesion zone with an alcohol swab and letting that dry for a couple of minutes before you start adhering the kit. You'll also want to do this with the surface temperature between 72-110 degrees Fahrenheit, as the tape doesn't stick if it's frozen.  Once the surface of the wheel is prepped and ready to go, make sure you test fit each piece before peeling off the protective backing and adhering it into place. Be sure to apply a lot of pressure to ensure proper installation, then just repeat that same process for each piece.